![]() ![]() ![]() Pollution degree 2: Normally only dry, non-conductive pollution occurs. The pollution has no influence.įor example: a clean room or air-conditioned office environment. Altitude Operating: less than 3 km Non-operating: less than 15 km Installation (overvoltage) Category This product is powered by mains conforming to installation (overvoltage) category II.RIGOL Pollution Degree Degree 2 Pollution Degree Definitions Pollution degree 1: No pollution or only dry, non-conductive pollution occurs. WARNING Inadequate ventilation may cause temperature increase which would damage the instrument.RIGOL Working Environment Temperature Operating: 0℃ to +50℃ Non-operating: -40℃ to +70℃ Humidity 0℃ to +30℃:≤95% relative humidity +30℃ to +40℃:≤75% relative humidity +40℃ to +50℃:≤45% relative humility WARNING To avoid short circuit inside the instrument or electric shock, please do not operate in humid environment. When using the oscilloscope in a bench-top or rack setting, provide at least 10 cm clearance beside, above and behind the instrument for adequate ventilation. RIGOL DS5022M MANUAL FREEPlease make sure that the air intake and exhaust areas are free from obstructions and have free air. Examples are measurements on circuits not derived from MAINS, and specially protected (internal) MAINS derived circuits.RIGOL Ventilation Requirement This oscilloscope uses fan to force cooling. ![]() Measurement Category Definitions Measurement category I is for measurements performed on circuits not directly connected to MAINS. WARNING This oscilloscope can only be used for measurements within its specified measurement categories. RIGOL DS5022M MANUAL SERIESThese terms may appear on the Product: DANGER WARNING CAUTION indicates an injury or hazard may immediately happen.RIGOL Measurement Category Measurement Category DS1000Z series digital oscilloscopes can make measurements in Measurement Category I. CAUTION Caution statements indicate the conditions or practices that could result in damage to this product or other property. These terms may appear in this manual: WARNING Warning statements indicate the conditions or practices that could result in injury or loss of life. Inadequate ventilation may cause increasing of temperature or damages to the device.RIGOL Safety Terms and Symbols Terms in this Manual. ![]() Any maintenance, adjustment or replacement especially to circuits or accessories must be performed by RIGOL authorized personnel. If you suspect damage occurs to the instrument, have it inspected by qualified service personnel before further operations. Do not touch exposed junctions and components when the unit is powered. Ground The Instrument.RIGOL Avoid Circuit or Wire Exposure. Only the power cord designed for the instrument and authorized by local country could be used. To prevent potential hazards, please use the instrument only specified by this manual. Information in this publication replaces all previously corresponding material.RIGOL Safety Requirement General Safety Summary Please review the following safety precautions carefully before putting the instrument into operation so as to avoid any personal injuries or damages to the instrument and any product connected to it. RIGOL reserves the right to modify or change parts of or all the specifications and pricing policies at company’s sole decision. Publication Number UGA Notices RIGOL products are protected by patent law in and outside of P.R.C. Trademark Information RIGOL is a registered trademark of RIGOL Technologies, Inc. 2013 RIGOL Technologies, Inc.RIGOL Guaranty and Declaration Copyright © 2013 RIGOL Technologies, Inc. RIGOL User’s Guide DS1000Z Series Digital Oscilloscope Aug. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |